Remove the two screws securing the bracket (C) to the punch unit assembly (D).
9.
Connector
Release the hooks securing the sensor (punch unit motor encoder) (B) to the bracket (C).
10.
11.
Remove the sensor (punch unit motor encoder) (B).
Sensor (punch unit side registration pair) with bracket removal
Open the finisher front door assembly.
1.
Remove the rear upper cover. See
2.
Remove the upper media bin assembly. See
3.
Remove the top cover. See
4.
5.
Remove the punch carriage assembly. See
Remove the screw securing the cover (A) to the punch unit assembly (B).
6.
Remove the cover.
7.
B
C
Clamp
"Rear upper cover removal" on page
"Top cover removal" on page
"Punch carriage assembly removal" on page
B
A
"Upper media bin assembly removal" on page
4-348.
5058-030
D
4-306.
4-349.
4-301.
Repair information
4-325
Previous
Next
Go Back