Programming Instructions; Programming The Pabx - elmeg C46e Description And Installation

5

Programming Instructions

5.1

Programming the PABX

Please note that the PABX system should only be programmed by
trained personnel
5.1.1 Setup Programming with the PC
Setup programming via the PC is the preferred method. Windows 3.1,
Windows 95 or Windows 95 must be installed in your computer.
•
Connect the RS-232 port of the PABX to your PC using the
connecting cable (included in scope of supply) (see page 22).
•
Windows 3.1:
Place the CD-ROM CD ROM drive. Start the program "in-
stall.exe" on the CD-ROM. Follow the instructions given by
the installation program.
•
Windows 95/Windows NT:
Place the CD-ROM CD ROM drive. The installation program
is started automatically. follow the instructions given by the
installation program.
Installation:
•
Start the configuration software.
•
Programming your PABX.
5.1.2 Setup programming using the telephone
Before you begin programming, please read through the section on program-
ming. Then fill in the tables for programming as required by your PABX.
Setup programming and the tables are on the CD supplied with the system
under the file names "Einricht.PDF" and "Tabellen.PDF".
This course of action will simplify subsequent programming for you. Setup
programming for the PABX must be performed by an authorized subscriber
with a valid password.
.
111
a/b-ISDN