elmeg C46e Description And Installation page 96

4.14.3 External configuration of Follow Me
Using this function, you can configure call rerouting from an external subscriber.
To configure call rerouting from an external subscriber you must dial a dial-in
number (point-to-point connection) or an MSN (multipoint connection) that has
been assigned a service number (internal virtual subscriber) in the PABX. In the
initial state, 59 is the number for the service number. This number may not be
used in the switchable call modes, teams or TFE call modes.
The PABX checks the authorization for configuring call rerouting from external
callers on the basis of a PIN. The authorization PIN corresponds to the central
programmer PIN for the PABX (initial state - 0000).
Please change this PIN to prevent unauthorized access to the PABX.
elmeg C48m/C88m: To dial in to the PABX the analog port 8 (subscriber or
TFE) must be available at the time of the call. Only then is the PABX able to
process the PIN for proper authorization and the procedure for configuring call
rerouting.
b
Lift the receiver of your phone (external subscriber).
t
Dial the service number for your PABX.
(Multipoint connection: MSN
point-to-point connection: System number + extension)
Once remote access for call rerouting has been enabled, and if it is possible at
this time (analog port 8 available), you will hear the special dial tone at your
PABX. Set your phone to DTMF-mode or use a portable DTMF transmitter.
t
Enter the PIN for your PABX.
q
You will then hear the acknowledgement signal for about one
(1) second.
*64
Select this code.
t
Select the internal terminal extension (00.....99) that is to be
rerouted.
t
Select the internal terminal extension (00.....99) (call destinati-
on).
or
92
a/b-ISDN