Programming A Charge Limitation For A Specific Extension Number; Enabling Or Inhibiting An Extension Number (Msn) For Outgoing Calls - elmeg CS410 Operating Instructions Manual

Telephones
Hide thumbs Also See for CS410:
Table of Contents

Advertisement

for entering letters, digits and special characters are described on page
11.
»delete?«
All charge data stored in the telephone are deleted. Recognition and sa-
ving of the procedure that is used for transfer of cost information (see
page 43) is then re-activated.
Programming a charge limitation for a specific extension
number
You can set up a charge account for each number (MSN) that has been entered in the tele-
phone. An amount in the configured currency that is available for making calls will then be al-
located to this account for the defined number (MSN). Once this amount has been exhaus-
ted, only free-of-charge calls can be directed for this MSN extension number. When you
have programmed specific dial ranges for this telephone, calls with costs can be directed to
the unrestricted numbers.
If this limit is reached during an ongoing call, the call can be completed.
When the amount for the account is increased, or when the accrued charges are cleared
calls with costs can again be made.
Attention: Not all service providers transfer charge rate information. If you make
calls using a service provider which does not transmit charge information, the
charge account is ineffectual.
Configuration of a charge account for a phone number (MSN) is described as follows using
MSN1 as the example.
Begin as follows:
M
a
Configuration
t
Enter the amount that is available for this num-
O
ber for making calls.
Confirm your entry by pressing OK.
If you enter the amount available for making calls as »0«, the charge account is not activated.
Enabling or inhibiting an extension number (MSN) for out-
going calls
Each number stored in the phone (»MSN-1« ... »MSN-10«) can be enabled or inhibited sepa-
rately for outbound calls. If you have inhibited an MSN for outgoing calls, no outgoing calls
can be initiated through this number (e.g. MSN assignment via function key). Incoming calls
can continue to be received by this number.
If you attempt to set up a call using a number that has been inhibited for dialing, the following
s
s
MSN
Use
s
MSN-1
MSN-10
...
ˆDial inhib. by charge
ˆLimit/GBP>10`
¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬
>
s
Charge
45

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cs410-u

Table of Contents