Connection/Callcharges - elmeg C46e Description And Installation

t
Enter the external number.
The external subscriber is called.
4.22

Connection/Callcharges

elmeg C46e: The PABX can store up to 1000 connection data records
elmeg C48m/ C88m: The PABX can store up to 2000 connection data records.
The connection/call charges can be displayed on ISDN terminals and on analog
terminals designed for this. The PABX can store connection data records which
can then be output at the printer, the PC or a laptop. Output and storage of
these call data records can be defined for certain or all terminals by appropriate
programming. In the initial state all incoming external calls which have been
assigned a project number and all external calls which you have initiated are
stored. You can use a terminal emulation program, a printer or the charge data
processing program from elmeg to output the call data records.
4.22.1 Call charge account (charge limit,
allowance account)
An account for call charges can be set up for each internal subscriber. The
charge rates or amounts available to the subscriber for making calls are defined
in this account. Once the rates or available amount has been exhausted, the
subscriber can then only make internal calls. If a limit is reached during a call,
the call can nevertheless be completed.
External calls are possible again after increasing the units or available amount
on the call account.
Please note that in order to use this feature the call charge account must
be activated for the subscriber and charge rate transfer must be applied
for at the network service provider.
If the network service provider transfers charge rate units, you must enter
the number of units in the call charge account. If the provider transfers allo-
wance amounts, you must enter the amount for the call charge account,
e.g. 100 corresponds to DM100, S100, SF100 or 100 charge rate units,
depending on the configuration of the network service provider.
102
a/b ISDN
a/b-ISDN