elmeg C46e Description And Installation page 58

3.1.1 Commissioning at a point-to-point connection
Your PABX is set up for point-to-point connection when it is switched on. You
can already. make inhouse calls to analog extensions. In order that your
terminals can also be reached by external parties, you must now program the
system number.
b
Lift up the receiver of your phone. You will hear the internal dial
tone.
**
Press the asterisk (*) button two times.
q
You will then hear the acknowledgement signal.
====
Enter your 4-digit password, e.g. 0000
(in the initial state).
12
Select this code.
0
Select the module (in this example Module 0= motherboard).
4
Select the connection (in this example Port 4= S04:EXT).
t
Enter the system number (ohne Vorwahl und Durchwahl).
#
End entry.
a
Hang up the receiver.
The terminals of your PABX can now be reached directly by external callers
and you can make external calls.
Example: Commissioning at a point-to-point connection
The network service provider has assigned you your system numbers and
number block 00.....49. These direct dial-in numbers must be dialed by an
external caller to reach a defined terminal. The number at which you can be
reached by an external caller is your system number, e.g. 12345 and the direct
dial-in number 00...49.
54