elmeg C46e Description And Installation page 113

for your PABX.
This remote configuration option involves one (1) call to the Service Center that
is subject to charges. You can terminate the data link to the Service Center at
any time by hanging up the receiver.
4.26.3 Incoming RMA Connection
An external subscriber (e.g. your dealer) can dial in to the PABX when remote
access has been enabled. You can authorize a defined external subscriber for
dial-in, and also define the time period during which the call can take place.
Enabling the PABX is then limited to 20 minutes. When an external subscriber
dials in to the PABX the system compares the number of the subscriber that
is transmitted to the number that you have programmed to check the autho-
rization for the dial-in call.
This remote configuration option does not involve any call to the Service Center
that is subject to charges; the charges for this call are covered by the Service
Center.
Terminating an active incoming RMA connection
You can terminate a connection coming from the Service Center using the
following procedure:
b
Lift up the receiver of your phone. You will hear the internal dial
tone.
#792
Select this code.
q
You will then hear the acknowledgement signal for about one (1)
second.
a
Hang up the receiver.
Canceling the clearance (enabling) for an incoming RMA connection
You can also cancel a programmed clearance for dial-in by an external
subscriber. An existing, active RMA connection will not be terminated by this.
b
Lift up the receiver of your phone.
You will hear the internal dial tone.
109