elmeg C46e Description And Installation page 59

3.1.2 Commissioning for a point-to-multipoint connection
Install your PABX as described in "Installation of the PABX". Make all necessary
connections, including the 230 V AC power supply connection, for your system.
An internal MSN must be assigned to each ISDN terminal (telephone, fax Gr.
4, PC card) that is to be operated at the internal ISDN multipoint connection.
This internal MSN is one of the internal numbers 00...99. Enter the internal
number you wish to have as the MSN as described in the Operating Manual
for the ISDN terminal.
Switching over to multipoint connection
When switched on, your PABX is set up for point-to-point connection. There-
fore, you must first switch it over to multipoint connection.
b
Lift up the receiver of your phone. You will hear the internal dial
tone.
**
Press the asterisk (*) button two times.
q
You will then hear the acknowledgement signal.
====
Enter your 4-digit password, e.g. 0000 (initial state).
q
You will then hear the acknowledgement signal.
10
Select this code.
0
Select the module (in this example Module 0= motherboard).
4
Select the connection (in this example Port 4= S04:EXT).
or
2 *
Select the connection (in this example elmeg C46e connection
ISDN S0 ext.)
#
End entry.
q
You will then hear the acknowledgement signal.
a
Hang up the receiver.
The PABX is now reset automatically.
55