elmeg C46e Description And Installation page 61

0
Select the module (in this example Module 0= motherboard).
4
Select the connection (in this example elmeg C48m / elmeg
C88m port 4= S04:EXT).
or
2
Select the connection (in this example elmeg C46e
port 2 = S0 Ext.).
0
Select the MSN/DDI index (in this example = 0)
10
Select the terminal number, in this example = 10.
q
You will then hear the acknowledgement signal.
a
Hang up the receiver.
The terminal with the number 10 of your PABX can now be reached directly by
external callers.
3.1.3 Commissioning of ISDN PC cards with "CAPI 1.1 interfaces"
Install the PC card in your PC. Look for the EAZ-MSN correspondence table
(EAZ map) in the operating manual for the PC card. Assign an "internal direct
dial-in number" (inhouse extension number) to EAZ 0....9. When doing this,
observe the information provided for setup programming of the PABX in the
Section "Assigning multiple subscriber numbers". Start the application program
for your PC card. Configure the defined EAZ and enter the code for seizure of
the external ISDN connection (in the initial state = "0").
Example:
•
Your number with direct dial-in number 26 at which your PC
card is to be reached is 12345-26.
•
In a standard scenario, you have assigned this direct dial-in
number the number 26 in setup programming for the PABX.
Then, during configuration of the PC card you assign the direct dial-in number
(MSN) 26 to EAZ 8.
57