Led Functions For The Pabx Systemselmeg C48M And Elmeg C88M - elmeg C46e Description And Installation

1.5 LED Functions for the PABX Systems
elmeg C48m and elmeg C88m
Two function indicator LEDs are located on the back of the cover (Installation
Instructions, Figure 1) of the PABX. They are located on the right side under
the cover and are visible from the outside. There are no LEDs on the elmeg
C46e PABX.
Green LED lights up:
Green LED off:
Red LED lights up:
Both LEDs light up:
Both LEDs off:
Green LED flashes:
When the PABX is switched on, all the LEDs will light up for around 6...10
seconds. After this, the red LED will go out when the system is in operation.
The green LED indicates correct operation.
PABX in operation.
Hardware error.
Error indicators.
Runup phase (initialization)
after switch-on.
Hardware reset or no
power supply to the PABX.
An internal ISDN connection is overloaded.
The Intelligent Power Management system
will quickly deactivate the ISDN connection.
7