elmeg C46e Description And Installation page 60

You can now make internal calls to analog terminals. In order that your terminals
can be reached specifically by external callers, you must now assign the internal
numbers for the terminal to an MSN (see Programming). You will be informed
of your MSNs when your application for this service has been approved by the
network service provider.
Example: Commissioning at a point-to-multipoint connection
You have been allotted the MSNs 12345, 12346 and 12347 by the network
service provider, for example. These MSNs must be dialed by an external caller
in order to reach a defined extension. The number at which an external caller
can reach you is 12345, for example. If, for example, your telephone, with the
inhouse extension number 10, is to be called when this number is dialed,
proceed as follows:
b
Lift up the receiver of your phone. You will hear the internal dial
tone.
**
Press the asterisk (*) button two times.
q
You will then hear the acknowledgement signal.
====
Enter your 4-digit password, e.g. 0000 (initial state).
q
You will then hear the acknowledgement signal.
16
Select this code.
0
Select the module (in this example Module 0= motherboard).
4
Select the connection (in this example elmeg C48m / elmeg
C88m port 4= S04:EXT).
or
2
Select the connection (in this example elmeg C46e ISDN con-
nection S0 ext.).
0
Select the MSN/DDI index (in this example = 0)
t
Select the first MSN (in this example = 12345)
#
Press the # key, to end your entry.
q
You will then hear the acknowledgement signal.
17
Assign the MSNs to the terminals.
56