elmeg C46e Description And Installation page 77

t
Dial the inhouse extension number you wish to call.
You will hear the ringing tone .
The inhouse subscriber is being called.
r
(If you hear the busy signal, press the
signal button again to retrieve the call on hold.)
a
Hang up your receiver.
The inhouse subscriber is being called. The inhouse subscriber
being called lifts up his/her receiver and continues with the call.
4.6.4 Enquiry call
With the enquiry call function it is possible to interrupt an internal or external
call in order to conduct an enquiry call. The other party can not hear your enquiry
call. When you complete your enquiry call, you can continue with your call that
was in progress. If so programmed, the party on hold will hear music on hold.
g
You are conducting a call.
You would like to make an enquiry call.
R
Press the flash button for analog telephones. You will then hear
the internal dial tone.
t
Dial the number of the inhouse party you wish to call.
You will hear the ringing tone .
The inhouse subscriber is called and lifts up the receiver.
g
Conduct your enquiry call.
To end an enquiry call (specific for ISDN terminal), press the dis-
connect button on your ISDN phone
or or
R*1
With an analog terminal the flash button R must be pressed first
and then the code *1 dialed; the current call is then discon-
nected and you will be reconnected with the first caller.
g
Continue with your call.
73
a/b-ISDN