Huper huberDVR 2400 User Manual page 39

5 Video settings
6 Respond to events by
Disconnect camera
7
Enable recording
8
Pre-alarm Video Recording
9
10
Detect events by
Information
11
Apply All
12
Choose the desired video resolution (320 x 240, 640 x
240, 640 x 480, 720x480 or 720x240) and video
standard (NTSC or PAL) to display live video. If the
camera is a PTZ camera, specify how it will be controlled.
Also determine whether or not to display captions on the
camera window.
Set up how Site Server will react to detected or manually
triggered events. (See page 36 for details.)
Select this option to disable the connection to a camera
and stop all tasks. Clear this option to re-establish camera
connection.
Select this option to enable digital recording. (See page
41 for more details.)
Pre-alarm video recording starts to record video before
the event occurred. The start recording time can be
before the event trigger time from 1 second to 10
seconds. The pre-alarm option is only available in the
event recording mode.
How to enable the pre-alarm recording
1. Go to the Preference/Camera page, select the camera
you want to enable the pre-alarm recording.
2. Check the Enable recording option.
3. Select the Event Recording mode.
4. Check the Pre-alarm option and specify the duration
between 1 second and 10 seconds.
5. When DVR detects an event and start to record, the
video in the pre-alarm duration is added into the event
record also.
Specify the methods to use for detecting events. There are
three methods: sensor detection, motion detection, or
manual trigger. (See page 42 for more details.)
When you are done configuring settings for cameras,
click the Information button to check your settings first
before saving them.
Click this button to use the same camera settings (except
for the camera name) for all video cameras.
39