Huper huberDVR 2400 User Manual page 211

connect from PTZ camera to the converter device. When we look
in front of the RJ11 connector, the left line is line 1 and the right
line is line 6. In the cable, line 4 and line 5 are used for RX+ and
RX- lines.
II. Connect the PTZ camera: Use DynaColor dome camera as an
example
Step 1: Adjust jumpers at the PTZ camera base.
Jumper
Dome ID
Duplex/Simplex
S2 & S1
Note:
1. After the PTZ camera has been set up
and the pan, tilt and zoom controls
seem not very well. You can switch
from duplex mode to simplex mode
and try again.
2. If there are two more PTZ cameras
connect to a serial port at the
computer, you must assign each PTZ
camera a unique ID.
Picture 2: Jumpers at the bottom side
Step 2: Connect cable from PTZ camera base to PTZ dome camera.
Connect a cable (comes in the camera pack) from the white connector (at the up-left
corner in Picture 3) of PTZ camera base to PTZ dome camera.
Picture 1: RJ11 connector (four lines inside)
Setting
001
Duplex
DynaColor protocol
of PZT camera base
211