The Ptz Camera Control Panel - Huper huberDVR 2400 User Manual

3. You can add a whole DVR site or only
selected cameras into the group:
• To add a whole DVR site, first make
sure that there is a check mark in its
check box (which means that all
cameras under this site are selected).
If there is no check mark, click the
check box. Then, drag and drop the
DVR site into the group.
• To add only certain cameras of a site
to the group, first select the desired
cameras. The check box on the
DVR site will then be marked with a
red box. Now drag and drop the
DVR site into the group.
• If you want to add only a single
camera from a site into the group,
select that camera then drag and
drop it into the group.
4. Repeat step 3 to add more DVR sites or
cameras into the group.

The PTZ Camera Control Panel

If there are PTZ cameras in any of the DVR sites, you can use the PTZ Camera Control
Panel to zoom in or out and pan around the monitored areas.
Click to open the PTZ Camera Control Panel.
The number buttons are Preset
buttons that store different
camera angle positions. Click a
number button to quickly
adjust the PTZ camera to a
predefined position.
14
Ch.2 Using huperRemote
Group of DVR sites
Group of cameras from multiple sites
This is the Pan and Tilt control.
Click one of the four arrow
buttons to adjust the camera
angle up, down, left, or right.
Click the "cross" button to stop
movement.
This is the Zoom control. Drag the
slider tab up to zoom in, or down to
zoom out.
When you release the mouse
button, the slider tab moves back to
the middle position automatically.