Monitoring A Site In Map Mode; Creating A Site Map - Huper huberDVR 2400 User Manual

3 Voice playback
The Voice input and Voice playback audio devices that you select must not be occupied by
another device when using the Talk feature. Please check the Audio tab in Preferences (see page
40) to see if the audio device is being used or not.

Monitoring a Site in Map Mode

To create a graphical layout of the site being monitored, switch to Map mode. Map mode allows
you to load a picture of the entire site being monitored and insert device icons on the picture to
indicate the locations where video cameras, sensors, and/or alarm devices are installed in the site.
This can help you to instantly identify the location where detected events occurred and take
immediate actions when necessary.
To switch to Map mode, click
creating a map layout of the monitored site.

Creating a site map

To create a map layout in Map Edit mode, place the camera, sensor, and output device icons on
the site map according to their actual installed locations. See the figure next page for step-by-step
instructions on how to load a picture of the site map and position icons on the map.
While positioning an icon, you can remove an icon from the map by dragging that icon out of
the map.
If you want to start all over and add icons to the map, click
map.
While you are adding camera icons onto the map, you may notice that their colors vary. Camera
icons may appear in one of these three colors:
Displays the audio device used by your playback
device (e.g. speakers) to play back the voice from
your counterpart. You can also adjust the playback
device's volume here. If you have more than one
audio device installed, select the device you want to
use from the drop-down menu.
. Then, click to switch to Map Edit mode and start
. This clears all icons from the
27