Playback Of A Sequence With Programmed Step Mode; Enable Sequence - MA SCANCOMMANDER User Manual

Scancommander Scancommander Scancommander Scancommander Scancommander
Running a sequence with
internally stored STEP
MODE
Green LED´s indicating
internal STEP MODE
Sequence recall without
going back to step 1
eMail: info@malighting.de . Tel.: + 49 9 31 49 79 40 . User's Manual Scancommander

6.2.5 Playback of a sequence with programmed STEP MODE

STEP MODE buttons switched off
SEQUENZ button 1-16
GREEN LED´s inside the SET MODE buttons
No green or red LED inside the SET RATE buttons

6.2.6 Enable Sequence

The ENABLE function like on Enable Chaser allows a sequence to resume
control of all channels without starting at step 1. A sequence, which has lost
access to some channels because of a direct access or memory recall, can
now continue as programmed.
ENABLE button.
... and simultaneously press ...
Sequence button of the actual sequence
(All red LED´s off)
Show the step mode of the next step, as it was set
when programming the sequence. If one of the green
LED´s is on, the sequence waits for a trigger signal.
By the GO button the next step can be recalled any
time.
The next step will follow automatically as soon as the
STEP TIME of the last step runs out.
Note:
The yellow LED inside the SET RATE button will not
show the internally programmed STEP TIME, but will
always show the rate set by the fader.
Keep button pressed ...
The next step of the sequence is enabled to control
all channels according its step matrix.
45 45 45 45
45