Playback Of Sequences; Playback Of A Sequence By Go Button - MA SCANCOMMANDER User Manual

Table of Contents

Advertisement

Scancommander
Scancommander
Scancommander
Scancommander
Scancommander
Starting a sequence
Red LED in the Step Mode
buttons
Green LED in the Step
Mode buttons
GO buttons
Set Time LED
Sequence via GO button
eMail: info@malighting.de . Tel.: + 49 9 31 49 79 40 . User's Manual Scancommander

6.2 Playback of sequences

A sequence is started by its respective button like any other memory.
By any memory or chaser, recalled by its respective button after the start of
the sequence, the sequence may loose its priority. If the memory was a
selective one, some of the channels may still be available for the sequence, if
it was a standard memory with fully selected STORE MATRIX, the following
steps of the sequence will no longer have any effect on stage.
A red LED in one of the STEP MODE buttons indicates, how the next step has
to be recalled. The internally stored step mode is indicated by the green
LED´s, but has no effect as long as a red one is on.
Green LED´s: Only if none of the red LED´s is on, the next step is triggered by
the internally stored step mode.
GO+ and GO- buttons are always working, like the EXTERN GO input via
1/4" jack on the back panel does.
SET TIME LED: if the LED is on, the x-fade time between the steps can be set
by the fader. The internally stored x-fade time of the steps has no effect.

6.2.1 Playback of a sequence by GO button

"GO BUTTON" Step Mode selected
SEQUENCE button 1-16
GO+ button
GO+
GO+
GO- button
(red LED on)
The LED in the button shows the selected sequence..
Recalls the first step of the sequence
Recalls the steps one by one.
Recalls the previous step.
Note: When using standard memories, the GO- but-
ton will really recall the right stage picture. When
using selective programmed steps, recalling a step
via GO- may have another effect than recalling this
step via GO+.
43 43
43 43
43

Advertisement

Table of Contents
loading

Table of Contents