Programming Chaser Parameters; Insert Or Delete Chaser Steps - MA SCANCOMMANDER User Manual

CHASER SPEED
STEP FADE
STEP TRIG
Step sequence
Insert a new step
Overwrite an old step
34 34 34 34
34
MA Lighting Technology GmbH . Dachdeckerstr. 16 . D-97297 Waldbüttelbrunn . Fax: + 49 9 31 4 97 94 29 . www.malighting.de

5.1.2 Programming chaser parameters

SPEED - sets the time between the different steps
STEP FADE- sets the x-fade time between the single steps
STEP TRIG - sets the trigpoint between the single steps
As the STORE MATRIX may be different from step to step, the listed parameters
are global for the complete chaser program.
Encoder 2
STEP FADE or
STEP TRIG
Encoder 3

5.1.3 Insert or delete chaser steps

Any time a chaser button is selected to store a new step, the step counter will
automatically jump to the old step number + 1. This way the new picture will
be added as the new last step of the chaser.
Encoder 1
INSERT
STORE button
Speed in Hertz (steps / sec.) and in seconds.
Inverts the respective block in the display. In case
LINK FADE is selected, the fade time is set in
percentage of the step time
Changes the selected parameter. The step fade is
allowed to be longer than the step time (SPEED).
This makes sense if the fading channels are not
selected in the next step. Otherwise they will not find
the time to do their fade. (>> selective programming)
Selection of a step number.
Shifts the selected step and all following steps one
step back and inserts the new picture at the selected
place.
Overwrites the selected step by the new picture. The
total number of steps stays unchanged.