Gateway ALR 8200R User Manual page 66

Warning!
For safety reasons, the top
cover must be closed and
secured while the system is
operating.
56 Gateway ALR 8200R User's Guide
5. Remove the drive from the drive bay assembly.
Figure 29: Removing a 3.5-inch Drive
6. Install the new drive into the drive bay and secure with the screws
removed in step 4.
Replace the drive bay assembly.
7.
8. Connect the drive cable to the drive, making sure that pin 1 on both
cable and drive are aligned.
Locate the diskette connector on the system board (see Figure 15 on
9.
page 29).
Connect the drive cable, making certain to match pin 1 on both
10.
connectors. On most standard cables, pin 1 is designated by a colored
wire on the cable. In some cases, the connector is keyed.
11. Connect the drive to the power supply, using an available power
connector.
Reinstall the top cover and power up the system.
12.
13. Enter the BIOS Setup program by pressing before the system boots.
F
2