Gateway ALR 8200R User Manual page 29

Dressing the Cables
Attach the cables to the cable retractor.
1. Route the cable(s) from the rear of the system drawer over to the cable
retractor, where it is mounted on the rear of the drawer.
Secure the cables to the cable retractor with tie wraps (the cable
2.
retractor is designed with tie holes to permit installation of tie wraps).
Figure 12: Routing Cable on the Cable Retractor
Leave enough slack in the cables to allow them to flex when the
3.
drawer is pulled out.
Check the cables for tight spots while the drawer is being pulled
4.
forward and pushed back into place. Check for stress points, especially
at the bends in the cable retractor and where the cable retractor is
mounted to the vertical mounting rail.
Dressing the Cables
Powering Up the System 19