Basic Features - Gateway ALR 8200R User Manual

22 Gateway ALR 8200R User's Guide

Basic Features

•
Support for up to two Intel Pentium
16-KB level one (L1) cache integrated with an additional 512-KB
of level two (L2) cache memory
•
SMP design supporting up to two processor modules; Intel MP
Specification V1.1 and 1.4 compliant
•
Autodetection of 66/100-MHz memory bus for all processor
speeds to accommodate processors using either memory bus speed
•
32-bit peripheral component interconnect (PCI) and industry
standard architecture (ISA) bus master; 64-bit data path processor
and memory data path; extended PCI-to-PCI bridge support
•
64-MB Error Checking and Correcting (ECC) memory,
expandable to 1-GB using ECC 60-ns 72-bit synchronous dynamic
random access memory (SDRAM) dual inline memory modules
(DIMMs)
•
Eight expansion slots: five PCI, one shared PCI/redundant array of
inexpensive drives- (RAID) port, one shared PCI/ISA, and one
ISA slot
•
Integrated 32-bit dynamic random access memory (DRAM) PCI
Graphics (Cirrus Logic GD54M30) with 2-MB DRAM
•
Integrated 10/100 Ethernet port using an RJ-45 connector
•
Integrated PCI Ultra2 small computer system interface (SCSI)
(Adaptec 7890) with two 68-pin connectors, dual-channel Ultra-
direct memory access (DMA) PCI integrated drive electronics
(IDE) interface, and diskette controller supporting 1.44 MB and
2.88 MB formats.
•
RAIDport ready: the shared PCI/RAIDport slot supports the
addition of a RAIDport card to provide RAID capability.
•
Low voltage differential (LVD) support for SCSI devices. LVD
SCSI allows faster disk access and greater data integrity
•
Power supply unit that supports dual 400W redundant power
supply modules with hot swap capability. The system ships with a
single module. If you install the optional second module, the power
supply supports load sharing and N+1 fault tolerance.
®
II processors, with dual