System Board Jumpers; Clear Cmos Jumper; Processor Setting Jumper - Gateway ALR 8200R User Manual

Warning!
Running the processor at a
speed higher than it is rated
for will cause irreparable
damage to your system.
120 Gateway ALR 8200R User's Guide

System Board Jumpers

These jumpers allow you to set certain characteristics of the system. Some
jumpers are reserved and are not described in this section. Do not change
any jumper unless it is necessary to configure the system. In some cases,
changing the settings of reserved jumpers can cause damage to the system
board.

Clear CMOS Jumper

This jumper allows you to clear the CMOS memory. You should only do
this if you cannot access the normal methods of modifying the CMOS and
modifications to the CMOS are necessary. Clearing CMOS memory
returns all BIOS Setup settings to the default values.

Processor Setting Jumper

This jumper allows you to set the speed of the processor. Both processors,
in dual processor configurations, must have the same speed rating. If
processors of different speeds are used in the same system, the processors
must run at the speed of the slower processor.
If you upgrade the processor(s), you must change the processor clock speed
jumper settings as well. Table 5 shows the proper jumpers settings for the
processor you have selected.
Table 5: Processor Speed Jumper Settings