Installing The Processor Drawer In The Rack - Gateway ALR 8200R User Manual

Note:
Drawer heights are
measured in "U's." Each U
is 1.75 inches, measured
vertically on the rack. Your
processor drawer is a 4U
drawer, and is 7 inches
high.
8 Gateway ALR 8200R User's Guide

Installing the Processor Drawer in the Rack

Rails must be installed on the processor drawer and in the cabinet before
you can install the processor drawer.
Installing the Mounting Rails
Install the mounting rails on the processor drawer.
Installing the Mounting Rails
1. After unpacking the processor drawer, remove the side rails from the
mounting rails by depressing the retention clips and sliding them off.
Mount the side rails on the processor drawer with the twelve (12)
2.
screws provided. The retention clips should go toward the rear of the
cabinet.
Figure 4: Installing the Mounting Rails