Firewall Settings - Fujitsu ETERNUS DX200F Configuration Manual

Chapter 5 General Settings
5.6

Firewall Settings

2
When the RMT port is used, connect the connector of the LAN cable to the RMT port of Controller 0
(CM#0) and Controller 1 (CM#1).
3
Connect the LAN cables of the MNT port to the network of the customer. If the RMT port is used for
remote support, connect the LAN cable of the RMT port to the network for remote support.
5.6 Firewall Settings
Set the firewall for each service. The settings are required respectively for the MNT port and the RMT port.
If both HTTP connection and HTTPS connection are disabled, the device is inaccessible via ETERNUS Web
•
GUI.
If both Telnet connection and SSH connection are disabled, the device is inaccessible via ETERNUS CLI.
•
If the network environment is not set up, the ETERNUS DX Discovery function is enabled. Some functions
•
are not available when the ETERNUS DX Discovery function is enabled for the MNT port. Make sure to set
up the network environment and disable the ETERNUS DX Discovery function.
1
Start the Web browser and log in to ETERNUS Web GUI with the IP address that is set in
"5.4 Storage Management (Initial Setup 1)" (page
2
Click the [System] tab on the navigation of the ETERNUS Web GUI screen.
3
In [Category], click [Network].
The [Network] screen appears.
FUJITSU Storage ETERNUS DX200F All Flash Array Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
40).
46
Step 6 in
P3AM-8462-01ENZ0