Fujitsu ETERNUS DX200F Configuration Manual page 123

Chapter 9 Advanced Copy Settings
9.2 Performing a Copy (SnapOPC+)
10
Use the same method to create sessions for the remaining six generations.
Specify from "No.: 3, Name: sdv1" through to "No.: 8, Name: sdv6" for the copy destination volumes.
11
After all of the sessions are created, click the number of sessions in [SnapOPC+ Sessions].
12
Check the status of the copy source volume and the copy destination volume.
In this case, the copy source volume number is "0" and the copy destination volume numbers are from
"1" through to "7".
13
Open [Disk Management] from [Computer Management].
FUJITSU Storage ETERNUS DX200F All Flash Array Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
123
P3AM-8462-01ENZ0