Copy Parameter Settings - Fujitsu ETERNUS DX200F Configuration Manual

Chapter 9 Advanced Copy Settings
9.1 Advanced Copy Basic Settings
9.1.3

Copy Parameter Settings

Set the parameter and the area allocation unit (SDPE) to execute notification automatically when the SDP
capacity becomes insufficient while SnapOPC+ is running.
The following four types of notification methods are available: Email, SNMP, Trap, and Syslog. The method
that is specified in
whether to enable notification and the notification method when enabled in advance.
If the data to be copied exceeds the physical capacity of the copy destination (if no SDP with free space
exists), the copy session and the copy sessions of earlier generations cause an error.
Notification occurs only once for each policy level. No notification is sent even if the threshold is reached
within 24 hours from the previous notification. Notification is sent after 24 hours have passed.
When the thresholds of multiple levels are reached at the same time, the highest level of notification is
sent.
1
Click the [Advanced Copy] tab on the navigation of the ETERNUS Web GUI screen. Then, click [Snap Data
Pool] in [Category].
2
In [Action] on the [Setting] screen, click [Modify Copy Parameter].
3
Set the required items and click the [Modify] button.
4
In the confirmation screen, click the [OK] button.
Copy table size setting starts.
"6.1 Event Notification Setup" (page 59)
FUJITSU Storage ETERNUS DX200F All Flash Array Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
is used as the notification to the user. Specify
119
P3AM-8462-01ENZ0