ETERNUS DX200F All Flash Array
An installation space and network environment must be prepared in advance.
Prepare the following manuals:
Manuals for the ETERNUS DX200F All Flash Array
Related manuals, such as manuals for the server or the networking equipment that is used
Site Planning Guide
Check that the installation area meets the space requirements of the rack in which the ETERNUS DX200F All Flash
Array (hereafter referred to as "ETERNUS DX") is to be installed.
Environmental considerations for installation
Check if the installation area for the ETERNUS DX meets the environmental conditions and installation environment
Check the type and the number of power outlets/sockets that are required to install the ETERNUS DX.
Configuration Guide (Basic)
Configuration Guide (Web GUI)
Completing and attaching the Network Settings label
Write down the IP address for the ETERNUS DX on the Network Settings label and attach it inside the rack.
Settings for the PC
Setup Network Environment
IP address : 192.168.1.2
Subnet mask : 255.255.255.0
Set the Web browser
Refer to "Configuration Guide (Web GUI)" for details on the settings that are required.