Wake On Lan Settings - Fujitsu ETERNUS DX200F Configuration Manual

Chapter 7 Power Control Setup
7.3

Wake On LAN Settings

7.3 Wake On LAN Settings
A network environment needs to be set to receive magic packets that are used by Wake On LAN for the ETER-
NUS DX.
The procedure to set Wake On LAN is as follows.
1
On the navigation of the ETERNUS Web GUI screen, click [System].
The [System] screen appears.
2
In [Category], click [Network].
The [Network] screen appears.
3
In [Action], click [Setup Network Environment].
The [Setup Network Environment] screen appears.
4
In the [Setup Network Environment] screen, select [Enable] for [Wake On LAN].
• For operations with cluster connections, set the IP address of the Slave CM for the "Slave IP Address"
of the MNT port.
• To control power supply with servers in a network to which the ETERNUS DX does not belong, set
"Gateway" and specify the server IP address or the network address in "Allowable IP Address".
5
Click the [Set] button.
A confirmation screen appears.
6
Click the [OK] button.
The network environment settings are applied.
FUJITSU Storage ETERNUS DX200F All Flash Array Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
81
P3AM-8462-01ENZ0