Firewall Settings - Fujitsu ETERNUS AF250 S2 Configuration Manual

Chapter 5 General Settings
5.6

Firewall Settings

5.6 Firewall Settings
Set the firewall for each service. The settings are required respectively for the MNT port and the RMT port.
If both HTTP connection and HTTPS connection are disabled, the device is inaccessible via ETERNUS Web
•
GUI.
If both Telnet connection and SSH connection are disabled, the device is inaccessible via ETERNUS CLI.
•
If the network environment for the MNT port is not set up, some functions will be unusable. Make sure
•
to set up the network environment.
1
Start the Web browser and log in to ETERNUS Web GUI with the IP address that is set in
"5.4 Storage Management (Initial Setup 1)" (page
2
Click the [System] tab on the navigation of the ETERNUS Web GUI screen.
3
In [Category], click [Network].
The [Network] screen appears.
4
Select the port to be set. In [Action], click [Setup Firewall].
FUJITSU Storage ETERNUS AF250 S2, ETERNUS AF250 All-Flash Arrays Configuration Guide (Basic)
Copyright 2017 FUJITSU LIMITED
64).
72
Step 7 in
P3AG-1832-04ENZ0