Fujitsu ETERNUS DX200F Configuration Manual page 43

Chapter 5 General Settings
5.4 Storage Management (Initial Setup 1)
(2)
Click the [OK] button.
The Thin Provisioning is set and the change completion screen appears.
(3)
Click the [Done] button.
The [Register Advanced Copy License] screen appears.
5
Advanced Copy license registration
Click the [Skip] button to proceed to the [Setup Network Environment] screen.
When registering the copy license for ETERNUS SF AdvancedCopy Manager, refer to the manuals for
ETERNUS SF AdvancedCopy Manager.
6
Network environment setup
Set the ETERNUS DX environment for network communication.
• Do not use the RMT port for an operation management LAN. Use the RMT port only for remote sup-
port.
• Configure the IP address for the MNT port with an IP address in a different subnetwork than the
RMT port.
When specifying the IP address of the Slave CM, specify an IP address that is in the same subnet
•
but is different from the IP address of the Master CM.
Either or both an IPv4 address and an IPv6 address can be specified for the MNT port and the RMT
•
port.
FUJITSU Storage ETERNUS DX200F All Flash Array Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
43
P3AM-8462-01ENZ0