Server Connection Setup; Iscsi Initiator Parameter Settings (Connection Information Settings); Figure 8.1 Connection Configuration With Servers - Fujitsu ETERNUS DX200F Configuration Manual

Chapter 8 SAN Connection Settings
8.2

Server Connection Setup

8.2 Server Connection Setup
Set up the server as required to connect to the ETERNUS DX.
The IP address to connect to the iSCSI network must be set on the server before the ETERNUS DX is connected.
After the server connection setup is completed, confirm that the volumes in the ETERNUS DX can be recog-
nized by the server.

Figure 8.1 Connection Configuration with Servers

Server (host)
8.2.1

iSCSI Initiator Parameter Settings (Connection Information Settings)

Use the iSCSI Software Initiator to set the iSCSI initiator parameters.
After performing the settings, check the connection to the ETERNUS DX.
Turn on the ETERNUS DX while its iSCSI port is connected to the LAN port for iSCSI connection on the server
with the host interface cable. After confirming that the ETERNUS DX is in READY status, turn on the server.
1
On the [iSCSI Initiator Properties] screen, click the [Discovery] tab.
A LAN card#0
iSCSI multipath
connection
B LAN card#1
FUJITSU Storage ETERNUS DX200F All Flash Array Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
CA#0 Port#0 C
CM#0
CA#0 Port#0 D
CM#1
93
ETERNUS DX
P3AM-8462-01ENZ0