Initial Setup; Firewall Settings - Fujitsu ETERNUS DX200F Setup Manual

Initial Setup

4
Perform the settings that are required before operation of the ETERNUS DX on the Initial Setup screen.
Perform the following settings according to the wizard
screen:
●
Set Storage System Name
●
Change User Password
●
Set Thin Provisioning
●
Setup Network Environment
In the Setup Network Environment settings, set the
IP address of the MNT port to connect the ETERNUS DX
to the operation management LAN.
After the settings are complete, close the Web browser.
Establishing a Connection between the ETERNUS DX and the Operation Management LAN
5
Remove the LAN cable between the RMT port on Controller 0 and the PC terminal.
Connect the LAN cables of the MNT ports on Controller 0 and Controller 1 to the network of the customer.
Then start the web browser from the PC terminal that is connected to the network and log in to ETERNUS Web GUI
again with the IP address that is set in "Set Network Environment". After login, the Overview screen appears.

Firewall Settings

6
Set the firewall for each service.
1.
Click the [System] tab, click [Network] in [Category],
and then click [Setup Firewall] in [Action].
2.
Enable or disable each service. Make sure to disable
the ETERNUS DX Discovery function.
If the network environment is not set up,
IMPORTANT
the ETERNUS DX Discovery function is
enabled. Some functions are not available
when the ETERNUS DX Discovery function
is enabled for the MNT port. Make sure
to set up the network environment
and disable the ETERNUS DX Discovery
function.
FUJITSU Storage ETERNUS DX200F All Flash Array Setup Guide
5
Copyright 2014 FUJITSU LIMITED
P3AM-8482-01ENZ0