Aircoat Atomizing Fl At Jet Spray Process - WAGNER AquaCoat AirCoat GM 5000EACW Operating Manual

EDITION 04/2012
OPERATING MANUAL
4.4.1.2.2
AIRCOAT ATOMIZING FLAT JET SPRAY PROCESS
In the AirCoat process, high pressure of 3-15 MPa; 30-150 bar; 435-2176 psi is used to atomize the material.
The AirCoat air at 0-0.25 MPa; 0-2.5 bar; 0-36 psi produces a soft jet, which largely eliminates the problem of
overlapping boundaries. With shaping air the possibility exists of changing the jet spray width.
Advantages
High painting capacity
●
Low fogging tendency
●
Good fi nish
●
High viscosity paints can easily be applied
●
High endurance of the nozzles
●
Change in width the jet
●
PART NO. DOC2321362
Variable spray
jet width
AquaCoat GM 5000EACW
Shaping air
B_00020
Atomizing air
Air cap
31