H3C S5600 Series Operation Manual page 882

[Sysname] snmp-agent usm-user v3 managev3user managev3group authentication-mode
md5 passmd5 privacy-mode aes128 cfb128cfb128
# Set the VLAN-interface 2 as the interface used by NMS. Add port GigabitEthernet 1/0/2,
which is to be used for network management, to VLAN 2. Set the IP address of
VLAN-interface 2 as 10.10.10.2.
[Sysname] vlan 2
[Sysname-vlan2] port GigabitEthernet 1/0/2
[Sysname-vlan2] quit
[Sysname] interface Vlan-interface 2
[Sysname-Vlan-interface2] ip address 10.10.10.2 255.255.255.0
[Sysname-Vlan-interface2] quit
# Enable the SNMP agent to send traps to the NMS whose IP address is 10.10.10.1. The
SNMP community name to be used is public.
[Sysname] snmp-agent trap enable standard authentication
[Sysname] snmp-agent trap enable standard coldstart
[Sysname] snmp-agent trap enable standard linkup
[Sysname] snmp-agent trap enable standard linkdown
[Sysname] snmp-agent target-host trap address udp-domain 10.10.10.1 udp-port 5000
params securityname public
Configuring the NMS
The S5600 series Ethernet switches support H3C's QuidView NMS. SNMPv3 adopts user
name and password authentication. When you use H3C's QuidView NMS, you need to set
user names and choose the security level in [Quidview Authentication Parameter]. For
each security level, you need to set authorization mode, authorization password,
encryption mode, encryption password, and so on. In addition, you need to set timeout time
and maximum retry times.
You can query and configure an Ethernet switch through the NMS. For more information,
refer to the corresponding manuals of H3C's NMS products.
Authentication-related configuration on an NMS must be consistent with that of the devices
for the NMS to manage the devices successfully.
1-9