Enabling Sending Trap Message When A Radius Server Goes Down - H3C S5600 Series Operation Manual

Configuring the
RADIUS client
The RADIUS service configuration is performed on a RADIUS scheme basis. In an actual network
environment, you can either use a single RADIUS server or two RADIUS servers (primary and
secondary servers with the same configuration but different IP addresses) in a RADIUS scheme. After
creating a new RADIUS scheme, you should configure the IP address and UDP port number of each
RADIUS server you want to use in this scheme. These RADIUS servers fall into two types:
authentication/authorization, and accounting. And for each type of server, you can configure two
servers in a RADIUS scheme: primary server and secondary server. A RADIUS scheme has some
parameters such as IP addresses of the primary and secondary servers, shared keys, and types of the
RADIUS servers.
In an actual network environment, you can configure the above parameters as required. But you should
configure at least one authentication/authorization server and one accounting server, and keep the
RADIUS server port settings on the switch consistent with those on the RADIUS servers.
Actually, the RADIUS service configuration only defines the parameters for information exchange
between switch and RADIUS server. To make these parameters take effect, you must reference the
RADIUS scheme configured with these parameters in an ISP domain view (refer to
Creating a RADIUS Scheme
The RADIUS protocol configuration is performed on a RADIUS scheme basis. You should first create a
RADIUS scheme and enter its view before performing other RADIUS protocol configurations.
Follow these steps to create a RADIUS scheme:
To do...
Enter system view
Task
Configuring Shared Keys for RADIUS Messages
Configuring the Maximum Number of RADIUS Request
Transmission Attempts
Configuring the Type of RADIUS Servers to be Supported
Configuring the Status of RADIUS Servers
Configuring the Attributes of Data to be Sent to RADIUS Servers
Configuring the Local RADIUS Server
Configuring Timers for RADIUS Servers
Enabling Sending Trap Message when a RADIUS Server Goes
Down
Refer to the configuration of the RADIUS client
Use the command...
system-view
—
2-12
Remarks
Optional
Optional
Optional
Optional
Optional
Required
Optional
Optional
—
AAA Configuration).
Remarks