Gvrp Configuration Example - H3C S5600 Series Operation Manual

Display the settings of the GARP timers
Display GVRP statistics
Display the global GVRP status
Clear GARP statistics

GVRP Configuration Example

GVRP Configuration Example
Network requirements
Enable GVRP on all the switches in the network so that the VLAN configurations on Switch C and
Switch E can be applied to all switches in the network, thus implementing dynamic VLAN
information registration and refresh.
By configuring the GVRP registration modes of specific Ethernet ports, you can enable the
corresponding VLANs in the switched network to communicate with each other.
Network diagram
Figure 1-2 Network diagram for GVRP configuration
Configuration procedure
1) Configure Switch A
# Enable GVRP globally.
<SwitchA> system-view
[SwitchA] gvrp
# Configure GigabitEthernet1/0/1 to be a trunk port and to permit the packets of all the VLANs.
[SwitchA] interface GigabitEthernet 1/0/1
[SwitchA-GigabitEthernet1/0/1] port link-type trunk
[SwitchA-GigabitEthernet1/0/1] port trunk permit vlan all
# Enable GVRP on GigabitEthernet1/0/1.
[SwitchA-GigabitEthernet1/0/1] gvrp
[SwitchA-GigabitEthernet1/0/1] quit
# Configure GigabitEthernet1/0/2 to be a trunk port and to permit the packets of all the VLANs.
To do ... Use the command ...
display garp timer [ interface
interface-list ]
display gvrp statistics
[ interface interface-list ]
display gvrp status
reset garp statistics
[ interface interface-list ]
1-7
Remarks