H3C S5600 Series Operation Manual page 317

The filter-policy import command filters the RIP routes received from neighbors, and the routes
being filtered out will neither be added to the routing table nor be advertised to any neighbors.
The filter-policy export command filters all the routes to be advertised, including the routes
redistributed with the import-route command and routes learned from neighbors.
You can also use the filter-policy export command to filter outgoing routes redistributed from a
specified routing protocol.
Setting RIP preference
Follow these steps to set RIP preference:
To do...
Enter system view
Enter RIP view
Set the RIP preference
Enabling load sharing among RIP interfaces
Follow these steps to enable load sharing among RIP interfaces:
To do...
Enter system view
Enter RIP view
Enable load sharing among
RIP interfaces
Configuring RIP to redistribute routes from another protocol
Follow these steps to configure RIP to import routes from another protocol:
To do...
Enter system view
Enter RIP view
Configure a default cost for an
incoming route
Configure RIP to redistribute routes
from another protocol
Use the command...
system-view
rip
preference value
Use the command...
system-view
rip
traffic-share-across-interface
Use the command...
system-view
rip
default cost value
import-route protocol [ process-id |
allow-ibgp ] [ cost value |
route-policy route-policy-name ]*
3-7
Remarks
—
—
Required
100 by default
Remarks
—
—
Required
Disabled by default
Remarks
—
—
Optional
1 by default
Required
By default, RIP does not
redistribute any route from
other protocols.