Cluster Configuration; Configuring The Management Device - H3C S5600 Series Operation Manual

Cluster Configuration

Configuring the Management Device

Management device configuration task list
Complete the following tasks to configure management device:
Enabling NDP globally and on specific ports
Configuring NDP-related parameters
Enabling NTDP globally and on a specific port
Configuring NTDP-related parameters
Enabling the cluster function
Configuring cluster parameters
Configuring inside-outside interaction for a cluster
Configuring the network management interface for a cluster
To reduce the risk of being attacked by malicious users against opened socket and enhance switch
security, the S5600 series Ethernet switches provide the following functions, so that a cluster socket is
opened only when it is needed:
Opening UDP port 40000 (used for cluster) only when the cluster function is implemented,
Closing UDP port 40000 at the same time when the cluster function is closed.
On the management device, the preceding functions are implemented as follows:
When you create a cluster by using the build or auto-build command, UDP port 40000 is opened
at the same time.
When you remove a cluster by using the undo build or undo cluster enable command, UDP port
40000 is closed at the same time.
Enabling NDP globally and on specific ports
Follow these steps to enable NDP globally and on specific ports:
Enter system view
Enable NDP globally
Enable NDP
on specified
Ethernet ports
Task
To do...
In system view
Enter
In Ethernet
Ethernet port
port view
view
Use the command...
system-view
ndp enable
ndp enable interface
port-list
interface interface-type
interface-number
1-10
Remarks
Required
Optional
Required
Optional
Required
Required
Optional
Optional
Remarks
—
Required
By default, NDP is enabled
globally.
Use either approach.
By default, NDP is enabled
on a port.