Network Management Interface Configuration Example - H3C S5600 Series Operation Manual

Hide thumbs Also See for S5600 Series:

Operation manual (1278 pages)

Configuration (313 pages)

Operation manual (1096 pages)

Table of Contents

# Configure VLAN-interface 2 as the network management interface.

[aaa_0.Sysname-cluster] nm-interface Vlan-interface 2

# Configure the shared FTP server, TFTP server, logging host and SNMP host for the cluster.

[aaa_0.Sysname-cluster] ftp-server 63.172.55.1

[aaa_0.Sysname-cluster] tftp-server 63.172.55.1

[aaa_0.Sysname-cluster] logging-host 69.172.55.4

[aaa_0.Sysname-cluster] snmp-host 69.172.55.4

Perform the following operations on the member devices (taking one member as an example)

After adding the devices attached to the management device to the cluster, perform the following

operations on a member device.

# Connect the member device to the remote shared FTP server of the cluster.

<aaa_1.Sysname> ftp cluster

# Download the file named aaa.txt from the shared TFTP server of the cluster to the member device.

<aaa_1.Sysname> tftp cluster get aaa.txt

# Upload the file named bbb.txt from the member device to the shared TFTP server of the cluster.

<aaa_1.Sysname> tftp cluster put bbb.txt

After completing the above configuration, you can execute the cluster

{ member-number | mac-address H-H-H } command on the management device to switch to

member device view to maintain and manage a member device. After that, you can execute the

cluster switch-to administrator command to return to management device view.

In addition, you can execute the reboot member { member-number | mac-address H-H-H }

[ eraseflash ] command on the management device to reboot a member device. For detailed

information about these operations, refer to the preceding description in this chapter.

After the above configuration, you can receive logs and SNMP trap messages of all cluster

members on the NMS.