Dhcp Server Configuration Examples - H3C S5600 Series Operation Manual

To do...
Display information about address
binding
Display the statistics on a DHCP
server
Display information about DHCP
address pool tree
Clear IP address conflict statistics
Clear dynamic address binding
information
Clear the statistics on a DHCP
server
Executing the save command will not save the lease information on a DHCP server to the flash memory.
Therefore, the configuration file contains no lease information after the DHCP server restarts or you
clear the lease information by executing the reset dhcp server ip-in-use command. In this case, any
lease-update requests will be denied, and the clients must apply for IP addresses again.

DHCP Server Configuration Examples

Currently, DHCP networking can be implemented in two ways. One is to deploy the DHCP server and
DHCP clients in the same network segment. This enables the clients to communicate with the server
directly. The other is to deploy the DHCP server and DHCP clients in different network segments. In this
case, IP address assigning is carried out through DHCP relay agent. Note that DHCP server
configuration is the same in both scenarios.
DHCP Server Configuration Example
Network requirements
The DHCP server (Switch A) assigns IP address to clients in subnet 10.1.1.0/24, which is
subnetted into 10.1.1.0/25 and 10.1.1.128/25.
The IP addresses of VLAN-interface 1 and VLAN-interface 2 on Switch A are 10.1.1.1/25 and
10.1.1.129/25 respectively.
In the address pool 10.1.1.0/25, the address lease duration is ten days and twelve hours, domain
name suffix aabbcc.com, DNS server address 10.1.1.2, gateway 10.1.1.126, and WINS server
10.1.1.4.
Use the command...
display dhcp server ip-in-use { ip
ip-address | pool [ pool-name ] |
interface [ interface-type
interface-number ] | all }
display dhcp server statistics
display dhcp server tree { pool
[ pool-name ] | interface
[ interface-type interface-number ] |
all }
reset dhcp server conflict { all |
ip ip-address }
reset dhcp server ip-in-use { ip
ip-address | pool [ pool-name ] |
interface [ interface-type
interface-number ] | all }
reset dhcp server statistics
2-27
Remarks
Available in user view