Configuring The Voice Vlan To Operate In Manual Voice Vlan Assignment Mode - H3C S5600 Series Operation Manual

Hide thumbs Also See for S5600 Series:

Operation manual (1278 pages)

Configuration (313 pages)

Operation manual (11 pages)

Table of Contents

A port working in automatic voice VLAN assignment mode cannot be assigned to the voice VLAN

manually. Therefore, if a VLAN is configured as the voice VLAN and a protocol-based VLAN at the

same time, the protocol-based VLAN function cannot be bound with the port. For information about

protocol-based VLANs, refer to VLAN Configuration in this manual.

For a port operating in automatic voice VLAN assignment mode, its default VLAN cannot be

configured as the voice VLAN; otherwise the system prompts you for unsuccessful configuration.

When the voice VLAN is working normally, if the device restarts or the Unit ID of a device in a stack

changes, in order to make the established voice connections work normally, the system does not need

to be triggered by the voice traffic to add the port in automatic voice VLAN assignment mode to the local

devices as well as the IRF of the voice VLAN but does so immediately after the restart or the changes.