MUTOH Blizzard User Manual page 10

•
When handling ink cassettes or cleaning liquid, be careful that the liquid does not get in your eyes or on
your skin. However, if this happens, flush immediately with water and wash skin with soap. Otherwise,
your eyes may become congested or inflamed slightly.
immediately.
•
Do not disassemble cassettes. Otherwise, liquid may get in your eyes or on your skin.
•
For ALL details regarding the Mutoh inks and cleaning, refer to the Material Safety Data Sheets
enclosed with every new cassette.
•
Be careful not to pinch your fingers when opening and closing the front cover.
•
Follow the instructions below when connecting the network interface cable. Otherwise, electrical shock
or fire may occur.
Do not touch the connector.
►
Do not connect the network cable connector which does not have the same specifications as the
►
interface board.
•
When cutting the roll media, be careful of the following. Incorrect handling can result in injury to the
hands and fingers from the razor blade.
When holding the media, do not place fingers over the media cut groove.
►
Move the razor blade slowly along the media cutting groove.
►
•
Do not use thinner, benzene, alcohol or other active agents. Doing so may result in damage or paint
peeling from the casing.
•
Be careful not to spill water inside the printer. Doing so may result in a short circuit.
•
Be careful not to touch the heaters during or after operation. Doing so may result in burns.
•
Only use Mutoh Mild Solvent Ink and appropriate cleaning liquid for Blizzard Mild Solvent
•
Only use Mutoh Eco-Solvent Ultra and appropriate cleaning liquid for Blizzard Ultra
•
Never open the covers fixed with screws. Doing so may result in electrical shock or a malfunctioning of
the printer.
•
Do not touch the cutter blade. Doing so may result in bodily injury.
•
Do not cut hard objects or drop the cutter. Doing so may damage or chip the cutter blade.
•
Do not bend or pull the waste fluid tube. Doing so may cause waste fluid to leak out and malfunction, of
the product.
•
Do not touch the cleaning wiper or the head cap unit with bare hands. Use a dust free cloth and gloves
to clean.
•
Do not tilt the printer upside down. Doing so may cause ink to leak inside the printer. Movement after
transport is not covered by the warranty.
•
Have four or more people unpack and assemble the printer.
•
Have two or more people transport the printer.
•
Ensure that the plug has been disconnected from the power socket when it is not to be used for a long
time.
•
Earth wires must be connected to wires or terminals that fulfil the conditions below.
Earth terminals of power sockets.
►
Earth wires with copper morsel that is at least 650 mm under the ground.
►
•
Keep the printer horizontally during transportation.
If you feel discomfort, consult a doctor
10
User's Guide Blizzard
Chapter 1: Safety Instructions
AP-75260 – Rev. 2.1 – 15/01/08