Operation Panel During Printing; When Heaters Are Not Ready; When Heaters Are Ready - MUTOH Blizzard User Manual

7.3 OPERATION PANEL DURING PRINTING

When sending a file to your printer, the following messages can be displayed.

7.3.1 When heaters are not ready

When the heaters have not reached their target temperature, the following screen will be displayed:
The printer will wait to print until the heaters are ready.
It is possible, however, to start the print while heating.
Step 1 : Press the F3 key
Step 2 : Go to submenu 2/2 and press the F2 key to start the print nevertheless.

7.3.2 When heaters are ready

When heaters are ready, the printer will start printing. Three menus are available during operation. This is
only possible when the length of the job is provided by the RIP software.
or
or
Change the step
Perform a cleaning
Change heater settings
Only is menu 1/3, the job can be cancelled!
The time needed to finish the print will be displayed in the upper
left corner.
The total area already printed is displayed and visualised via a
status bar.
The size of the job will be displayed.
94
User's Guide Blizzard
Chapter 7: Printer menu
AP-75260 – Rev. 2.1 – 15/01/08