MUTOH Blizzard User Manual page 133

(5) Printouts are partially blurred or there are some missing nozzles.
Notes
Y
OU MAY NOT OBTAIN REASONABLE QUALITY WITH MEDIA OTHER THAN RECOMMENDED MEDIA
No.
1 The media is damped.
2 You used folded, creased or curled media.
3 Check the media for curling or lift off.
(6) Printing position is not correct (some positions are not printed.
No.
1 The loading position of the media is not correct.
2 You set the origin or starting position.
(7) Media jams occur frequently.
Notes
W
E CANNOT ENSURE CORRECT MEDIA FEEDING WITH MEDIA OTHER THAN RECOMMENDED MEDIA
No.
1 You did not use recommended media.
2 You used the printer in an environment other than
the specified environment.
3 You used old media.
4 You used folded, creased, or curled media.
5 Check the media for curling or lift off.
(8) Roll media cannot be cut correctly.
No.
1 The edge of the cutting blade is not sharp.
2 The roll media has static electricity.
3 Media is too heavy to be cut automatically.
(9) You cannot perform initial ink charging.
No.
1 The front cover is open or the hold lever is up.
2 Some of the 8 ink cassettes have not been loaded
properly.
Possible cause
Possible cause
Possible cause
Possible cause
Possible cause
Replace with new media.
Use the recommended media.
When using media other than recommended
media, set the following items in the media
setting menu.
•
Media
•
HeadHeight
•
Stiff
Load the media correctly.
Turn off the origin or starting position setting,
or make the setting again.
Use recommended media.
Use the printer in the specified environment.
Replace with new media.
Use the
When using media other than recommended
media, set the following items in the media
setting menu.
• Media
• HeadHeight
• Stiff
Replace the cutting blade.
Remove the static electricity on the roll media.
Cut the media manually.
Close the front cover and lower the hold lever.
Load all of the 8 cassettes properly.
133
User's Guide Blizzard
Chapter 8: Troubleshooting
.
Solutions
Solutions
.
Solutions
recommended media.
Solutions
Solutions
AP-75260 – Rev. 2.1 – 15/01/08