MUTOH Blizzard User Manual page 134

(10) Ink is not used though you performed initial ink charge.
No.
1 The ink cassette is cold or frozen.
2 You switched off the printer during the initial ink
charging.
3 The printer rarely prints correctly only after initial ink
charging.
4 Pumps or tubings are blocked
5 There is a leak, no vacuum, no air suction.
(11) The media is off or damaged when loading it.
Notes
R
EMOVE THE JAMMED OR DAMAGED MEDIA
No.
1 You did not use recommended media.
2 The loading position of the media is not correct.
3 Foreign material, such a piece of media, is attached
to the pressure rollers.
4 You used the printer in direct sunlight or other
locations not
environment.
5 You loaded sheet media into the printer.
6 You used folded, creased, or curled media.
7 Check the media for curling or lift off.
(12) Media is damaged during media Initial.
Notes
R
EMOVE THE JAMMED OR DAMAGED MEDIA
No.
1 You did not use recommended media.
2 The loading position of the media is not correct.
3 You did not load the media straightly into the printer.
4 Foreign material, such a piece of media, is attached
to the pressure rollers.
5 You used the printer in a location with air conditioner
or other location not appropriate for the specified
environment.
6 You loaded sheet media into the printer.
7 You used media folded, creased, damaged, torn,
curled.
Possible cause
,
REFERRING TO
Possible cause
appropriate for the
.
Possible cause
Leave the ink cassette in normal temperature
for at least three hours, and perform cleaning
a few times.
Switch on the printer to continue the initial ink
charging.
Perform cleaning a few times and check
again.
Replace the tubings.
Find the leak and repair it.
"W
HEN MEDIA JAMS OCCUR
Use recommended media.
Load the media correctly.
Clean the pressure rollers.
Use the printer in the specified environment.
specified
Set the SheetSize setting to Length or Width.
Replace with new media.
Use the
When using media other than recommended
media, set the following items in the media
setting menu.
• Media
• HeadHeight
• Stiff
Use recommended media.
Load the media correctly.
Load the media straightly into the printer.
Clean the pressure rollers.
Use the printer in the specified environment.
Set the SheetSize setting to Length or Width.
Replace the media.
134
User's Guide Blizzard
Chapter 8: Troubleshooting
Solutions
".
Solutions
recommended media.
Solutions
AP-75260 – Rev. 2.1 – 15/01/08