Responding To A Call While Busy; Using Answering Machine Emulation (Ame) - iPECS LDP-9008D User Manual

LIP-8012E & LIP-8024E Gigabit Phone
3.2

Responding to a Call While Busy

To answer a Call Waiting:
•
Press
•
Press the flashing
To activate One-time DND:
•
Press the DND button.
To send a Silent Text Message:
•
Press the programmed
•
Select the desired message to send.
3.3

Using Answering Machine Emulation (AME)

While you are busy on another call, you may receive a
Muted Ring, Camp-On tones, or Voice-Over
announcements. Muted Ring is provided over the
speaker of your Phone indicating a Call Waiting. You
also may receive Camp On tones, a burst of tones on
top of the existing call, as an indication of another call
waiting.
While busy, certain stations can activate Voice-Over to
your phone. In this case, audio is received from both
the active call and the Voice Over announcement at the
same time.
Respond to any of these Off-hook Signals in one of
several ways; place the existing call on Hold and
respond to the new incoming call, activate
DND, send a
call.
Silent Text Message requires a
(not available on a SLT or other non-display terminal).
The Attendant or Secretary may use Intrusion to
announce a call while you are busy.
/ , and/or
HOLD SAVE
/
CO IP LINE
When a call is connected to your voice mail, you can
screen the call as with a normal Answering Machine.
The caller's voice is played over your speaker while the
message is being recorded. There are two methods of
notification and call screening provided, LED blink mode
or Speaker hearing mode.
Ring Mode (iPECS-LIK & SBG)/LED Blink Mode
(iPECS-MG)—the Answering Machine Emulation (AME)
Flex button will flash to notify you of a call. You may
press the Flex button to hear the caller as the voice
message is stored.
Silent Text Message, or ignore the new
button.
button,
TEXT MESSAGE
19
User Guide
One-time
button
TEXT MESSAGE