Access Pbx Or Centrex Features; Access The Isdn Network; Using The Keypad Facility To Access Isdn Features - iPECS LDP-9008D User Manual

LDP-9008D & LDP-9030D
9.
PBX, C

9.1 Access PBX or Centrex features

The iPECS system has been designed to operate with a host
PBX system or Centrex services from your service provider.
The iPECS system connects to a host with analog CO lines.
When accessing a CO line, the phone will act as an extension
of the host, allowing access to the host system features using
the host dial codes. While on a call, use the Flash feature to
transfer calls to other host extensions or access features of the
host.
The Flash feature may be used on other CO lines to regain dial
tone from the CO line without relinquishing control of the CO
line to place another call.
To access PBX or Centrex features while idle:
•
•
•
To access PBX/Centrex features while on a
PBX/Centrex CO line:
•
•

9.2 Access the ISDN Network

9.2.1 Using the Keypad facility to access ISDN
Access to certain features of your ISDN services requires that
dialed digits be sent to the ISDN as data and not tones. In this
case, dialed digits are sent as 'Keypad messages'.
A Keypad Facility button must be assigned using the
Button program
services; however, actions other than dialing will deactivate the
Keypad Facility operation.
& ISDN
ENTREX
Lift the handset,
Select/dial access a PBX/Centrex CO line,
Dial PBX/Centrex feature code.
Select the
Flash
After receiving new dial tone, dial the PBX/Centrex feature
code.
features
procedures. Once active, dial into the ISDN for
FEATURES
soft button,
39
User Guide
Flex