Wp Sequence No; Warning Summary - Reeves G2 series Operation Manual

Operation & Maintenance w/IPB
Identifying WPs
Each WP is identified by a six-digit number. The first four digits are assigned sequentially. The last two digits, if other
than 00 (01, 02, 03, etc.), indicate WP revision level. WPs are revised due to equipment configuration differences,
support equipment differences, or other similar situations. For example:
•
WP 0005 00 might cover installation of a cable on a basic unit.
•
WP 0005 01 might cover installation of the same cable on a differently configured unit.
•
Installation of an alternate handle in place of the original handle, requiring a different procedure.
•
Installation of the handle using an alternate technique or different tools.
•
Installation of the handle using alternate fasteners.
Locating WPs
There are two ways to locate a WP when the number is not known, using the Table of Contents in the manual's front
matter and using the Index in the manual's rear matter.
Locating a WP in the Table of Contents
First determine the category of the WP subject and then find the appropriate chapter in the Table of Contents. Scan
the WP titles in that chapter until the WP subject matter is found. In the example below, it is desired to locate the
PMCS for the Operator (shaded). PMCS falls into the category of maintenance. Go to the Table of Contents and find
the chapter titled "Operator Maintenance Instructions." (Make sure the chapter applies to the appropriate
maintenance level). Scan the WP titles within that chapter until "PMCS" is found, and follow the leader line to find the
WP number.

WARNING SUMMARY

HOW TO USE THIS MANUAL
CHAPTER 1 - GENERAL INFORMATION, EQUIPMENT DESCRIPTION, AND THEORY OF OPERATION
General Information.................................................................................................. WP 0001
Equipment Data and Description.............................................................................. WP 0002
Theory of Operation ................................................................................................. WP 0003
CHAPTER 2 - OPERATOR INSTRUCTIONS
Description and Use of Operator Controls, Indicators and Connections.................. WP 0004
Flushing the System Procedures ............................................................................. WP 0005
G2 Start-up Procedures ........................................................................................... WP 0006
G2S Start-up Procedures........................................................................................ WP 0007
Part Number: 1006375
This document contains information proprietary to DHS Systems LLC and is intended solely for use by its customers. No portion of this document may be reproduced
for release to a third party without written consent of DHS Systems LLC.
G2 Series Decontamination Water Heater
TABLE OF CONTENTS
iii

WP Sequence No.

DHS Systems LLC