Reeves G2 series Operation Manual page 61

Operation & Maintenance w/IPB
INITIAL SETUP:
References
WP 0005, WP 0006, WP 0007, WP 0008
ITEM
INTERVAL
NO.
1 BEFORE
2 BEFORE
3 BEFORE
Part Number: 1006375
This document contains information proprietary to DHS Systems LLC and is intended solely for use by its customers. No portion of this document may be reproduced
for release to a third party without written consent of DHS Systems LLC.
G2 Series Decontamination Water Heater
OPERATOR MAINTENANCE INSTRUCTIONS
G2 SERIES DECONTAMINATION WATER HEATER
SERVICE – PMCS
Table 1. Operator Preventive Maintenance Checks and Service
ITEM TO BE
CHECKED
OR SERVICED
POWER
CORD
Inspect Check entire length of extension cord for
Electrical Cord cuts, gashes, or physical damage.
Test GFCI Test the GFCI in accordance with to the
specific GFCI.
GAUGES
Temperature 1. Check for serviceability.
Gauge
2. Verify if gauge operate properly.
Pressure 1. Check for serviceability.
Gauge
2. Verify if gauge operate properly.
FUEL TANK
Fuel Level Check for proper fuel level.
PROCEDURE
0013-1
0013
EQUIPMENT NOT
READY/
AVAILABLE IF:
If damage is noted,
replace cord before
operating the water
heater
If testing fails,
replace electrical
cord.
If unserviceable,
replace temperature
gauge.
Contact Reeves
EMS for
replacement gauge.
If unserviceable,
replace pressure
gauge.
Contact Reeves
EMS for
replacement gauge.
If fuel is low, fill tank
according to
manufacturer
recommendations.
DHS Systems LLC